The idChamp® RS3x RFID-NFC reader is a wireless BLE device. With optional HID firmware, it can optionally work in wireless HID mode. Instructions Power off your RS3x, remove the four lid screws, then remove the lid. Locate switches S3, S5. Use a small plastic device to change the switch settings if needed. Note: Image below …
NOTE: RS3 Has been discontinued. See the RS3xThese instructions are for units built after August 2019. These units will have a white UART connector on the PCB board next to banks S4 and S5 Getting Started To prepare your idChamp RS3 for ‘Always On’ mode, follow the instructions below. You’ll need a Phillips head screwdriver and …
Set Battery-Unit idChamp RS3 in ‘Always On’ Mode (Post August 2019) Read More »
This support article demonstrates the configuration settings required to accurately read iClass cards of various bit counts. If you are using or planning to use the idChamp RS3 with iClass cards with a bit count other than 26, this article is for you. To accurately read cards with bit counts other than 26, you need to …
How to configure the idChamp RS3 to read a specific bit count Read More »
This support article demonstrates how to remove keystroke delimiters from the idChamp RS3 Dual Engine RFID Reader with the RS3-NFC Setup application for iOS. This tutorial assumes that you have already installed the RS3-NFC Setup application for iOS. If you have not already done so, please do so now. Adjust the DIP Switches for BLE Mode You must …
How to remove idChamp RS3 keystroke delimiters on iOS Read More »
RS3 Has been discontinued. See the RS3x You can adjust the sleep timer for the idChamp RS3 Reader to allow for a longer timeout period or disable it completely. To do so, you will need a USB-RS232 adapter and a terminal program such as TeraTerm or PuTTY. Follow the steps below to configure this timeout period …
This Product is discontinued. See the RS3x. To prepare your idChamp RS3 for HID (otherwise known as “keyboard mode”), follow the instructions below. Use the DIP switch table at the end of this page for reference. 1. Power off your RS3 and take it out of its enclosure by unscrewing the four screws, then lifting the …
How to configure the idChamp RS3 for HID (keyboard) mode Read More »
This page serves as a complete guide on how to use RFIDeas pcProx Configuration Utility for Windows to configure the idChamp RS3 You will need the following for this tutorial: A Windows PC pcProx Configuration Utility for Windows installed [Download Link] idChamp RS3 [Purchase Here] USB to RS-232 adapter cable [Purchase Here] RS-232 to micro …
idChamp® RS3x Wireless RFID-NFC Smart Card Reader DIP Switch Settings for button power on mode. Set S3-3 ON for kiosk mode.
Set Wireless Mode FAST or HID You set idChamp® NF4x, RS4x, RS3x, DX1x RFID-NFC reader/writer wireless modes are set using the yACK FAST app. IMPORTANT – Only set NF4x Direct Mode model reader in HID Keyboard (KB) Mode. When you set the NF4x Smart Mode model to KB mode, it will not work. NF4x …
How to pair in Bluetooth SPP vs BLE the differences and similarities between the pairing process for Bluetooth SPP (Serial Port Profile) and Bluetooth Low Energy (BLE). Although these two Bluetooth profiles are commonly used for a variety of applications, the focus of this guide is on the implications related to using Serialio’s Bluetooth scanners …