Serialio

RS3x DIP Switch Settings for BLE Mode

You can set idChamp® RS3x RFID-NFC reader DIP switch settings for different operating modes. This page shows how to setup the RS3x DIP switch settings for BLE mode. You setup RS3x RFID engine using the RS3 NFC Setup iOS app. In addition, you setup RS3x RFID engine using the RS3 NFC Setup Android app.

Note: the RS3x model RFID-NFC reader switch settings differ from the RS3 model.

See here for RS3x DIP switch settings in cabled mode.


DIP Switch Setting Images For BLE Mode

DIP switch S3 and S5 settings for BLE mode are shown below.
You can see DIP switches S3 and S5 with the RS3x cover removed.

RS3x S3 & S5 DIP Switch Settings for BLE mode
RS3x S3 & S5 DIP Switch Settings for BLE mode

Note: S3-3 is ON for kiosk mode, OFF for battery mode

You must remove the RS3x from the case to have access to DIP switch S2.
DIP switch S2 settings for BLE shown below.

RS3x S2 DIP Switch Settings for BLE mode
RS3x S2 DIP Switch Settings for BLE mode


Leave a Comment

Your email address will not be published. Required fields are marked *