Inlay The tag inlay consists of the integrated circuit (IC), an antenna, and a substrate to hold it all together. The inlay, on its own, is a fully functional tag; ready to be packaged into either a smart label or another casing. Integrated Chip (IC) The IC is an electronic circuit or microchip that is […]
Components of an RFID Tag Read More »
The latest standardization of the Ultra-High Frequency RFID spectrum is the GS1 UHF Gen2 protocol (ISO/IEC 18000-63), which defines the technical specifications (e.g., physical/logical interactions between devices, anti-collision algorithms, security commands, etc.) for RFID devices operating in the frequency of 860–860 MHz. The ITU designated UHF (Ultra-High Frequency) as the radio frequency range of 300 MHz to
An Introduction to UHF RFID Read More »
Active Tag: A battery-powered RFID tag that powers the circuitry that transmits the signal to a reader. Active tags differ from passive tags in that they have longer read ranges, a higher price tag, and a larger size (due to the battery). Antenna: The element built into both RFID readers and tags that radiates and
The frequency range of an RFID system has a significant impact on multiple performance metrics like the read range and interference susceptibility, so it’s important to make sure you select the right frequency for your business application or use case. LF/NFC HF UHF Frequency range 125 – 134.2 KHz 13.56 MHz (global) 433, 865 – 828
The Difference Between the RFID Frequency Ranges (LF/HF/UHF) Read More »
The primary difference between active and passive tags is that active tags have their own power source (typically an embedded battery) and passive tags rely on the RFID reader’s propagation signal to power the tag. From this primary distinction stems a variety of considerations to make when deciding between the two types of tags. This article
The Difference Between Active and Passive RFID Tags Read More »
In its most rudimentary form, an RFID system is made up of two parts; a transponder (a tag) and an interrogator (a reader). The transponder, which consists of an inlay which has a microchip, an antenna, and usually a substrate (the stuff that holds the tag’s components together) and optionally an encasing to protect the inlay from
How Does An RFID System Work? Read More »
To configure the WiSnap adapter for software access point mode follow the below steps: 1. Connect the WiSnap adapter to your PC using a USB-RS232 cable. 2. Configure your terminal application (PuTTY, TeraTerm, etc.) with the settings: 9600 baud 8 data bits 1 stop bit no parity no flow control 3. Start the terminal application.
Configure software Access Point (AP) mode on WiSnap adapters Read More »
This app note demonstrates how to connect the WiSnap RS-232 dongle via Wi-Fi to an Android AP (access point) that is connected to the internet via a 3G/4G cellular network. To clarify, we are going to set up the Android device (with access to a cellular network) as a Wi-Fi access point, then configure the
How to use Android Wi-Fi AP to tether the WiSnap to a cellular network Read More »
Select A Terminal Application Before we begin, it’s important that you make sure that you have a compatible terminal emulator installed on your computer. Here, at Serialio, we often use our product, JavaTerm. There are also a myriad of different terminal emulators (for Mac and Windows) that will do just fine. If you don’t know
How to setup the WiSnap RS-232 adapter Read More »
This Product is discontinued. This guide will walk you through the process of configuring your BlueSnap module with a serial communication terminal on Windows. There are many serial communication terminals available, including JavaTerm and YAT. For this tutorial, we will be using Tera Term on a Windows 10 PC. Tera Term is a free and
How to configure the BlueSnap RS-232 to Bluetooth adapter Read More »