Author name: admin

For the idChamp RS3x see this page. This post shows how to use RS3 NFC Setup iOS app to load an hwg+ file to the idChamp RS3. If you do not have access to an iOS device, you can also setup the idChamp RS3 with the RS3 NFC Setup application for Android or pcProx configuration utility

This support article will walk you through how to use Serialio’s RS3 NFC Setup application for Android to configure your idChamp RS3. If you do not have access to an Android device, you can also configure your idChamp RS3 with the RS3 NFC Setup application for iOS or pcProx Configuration Utility for Windows. idChamp RS3-HSE

NOTE: RS3 Has been discontinued. See the RS3x These instructions are for RS3 units built after August 2019. These units will have a white UART connector on the PCB board next to banks S4 and S5. RS3 Getting Started To prepare your idChamp RS3 for BLE mode, follow the instructions below.  You’ll need a Phillips

NOTE: This product is discontinued. See the RS3xThese instructions are for units built BEFORE August 2019. These units will NOT have a white UART connector on the PCB board next to banks S4 and S5 Getting Started To prepare your idChamp RS3 for BLE mode, follow the instructions below.  You’ll need a Phillips head screwdriver

The idChamp® RS3x RFID-NFC reader is a wireless BLE device. With optional HID firmware, it can optionally work in wireless HID mode. Instructions Power off your RS3x, remove the four lid screws, then remove the lid. Locate switches S3, S5. Use a small plastic device to change the switch settings if needed. Note: Image below

NOTE: RS3 Has been discontinued. See the RS3xThese instructions are for units built after August 2019. These units will have a white UART connector on the PCB board next to banks S4 and S5 Getting Started To prepare your idChamp RS3 for ‘Always On’ mode, follow the instructions below.  You’ll need a Phillips head screwdriver and

This support article demonstrates the configuration settings required to accurately read iClass cards of various bit counts. If you are using or planning to use the idChamp RS3 with iClass cards with a bit count other than 26, this article is for you. To accurately read cards with bit counts other than 26, you need to