SerialMagic Support - Configure BlueSnap RS-232 Hardware(Using SerialMagic Pro - BlackBerry)
More ways to use SerialMagic.
Setup BlueSnap configuration wirelessly using SerialMagic Pro - BlackBerry
With SerialMagic Professional for BlackBerry, it is easy to modify BlueSnap settings, wirelessly!
Just download and install SerialMagic Professional on your BlackBerry, and then launch the SerialMagic Professional software.
Select Menu > Setup Remote BlueSnap (Note: older versions of SerialMagic will show "Configure" in place of "Setup") as shown below.
Power on the BlueSnap Bluetooth wireless module, then select OK in SerialMagic on the BlackBerry.
SerialMagic will perform Bluetooth Discovery and display the nearby BlueSnap device(s).
Select the BlueSnap Bluetooth module you wish to configure, in this example "BlueSnapXP-5F3D"
If the BlueSnap wireless Bluetooth module is not in the BlackBerry trustd Bluetooth devices list, then SerialMagic will perform Bluetooth pairing.
Note this step in the configuration process should only occur when the BlueSnap device is not trusted with the BlackBerry or
Bluetooth configuration of the module has changed since the last pairing with the BlackBerry.
If the Bluetooth pairing occurs, then you will again select the BlueSnap module from the Bluetooth devices list.
Power down the BlueSnap module when prompted by SerialMagic Pro. Power it on again only when prompted. (you have about 20 seconds to power up the module)
(This power cycle is cricital and configuration can't occur properly without it)
Shortly after, SerialMagic will begin to read the current configuration settings, you should notice the LED light on the BlueSnap flashing rapidly.
SerialMagic should then display configuration settings.
(Note these are the most common settings used, more advanced settings require other SerialMagic features or
can be configured with a terminal program and a cable connected to the BlueSnap)
Select the desired settings for the BlueSnap Bluetooth module to work with your serial device.
Settings that have been modified will have their label displayed in red. Select Save when ready to commit BlueSnap module configuration changes.
The selected settings will be saved. Using SerialMagic Pro, it's that easy!
Refer to the Advanced Command Interface guide for more details on configuring BlueSnap hardware.
(This document applies to the BlueSnapXP, BlueSnap Standard Male & Female, BlueSnap 9V, and BlueSnap AAA devices)
*To configure the BlueSnap USB module, use a Windows Terminal program or Serialio's USB-RN-X application.*
Download SerialMagic Professional